Wall insulation
The standard wall has 260 to 300 mm of wood fibre insulation. The whole wall is 354 to 405 mm thick. According to public technical descriptions, a typical prefabricated home usually has 100 mm of mineral wool, sometimes supplemented with polystyrene or PIR.
Wall build-up
From the inside out:
| Layer | Thickness |
|---|---|
| Bio board or clay plaster | 19 / 30 mm |
| Service cavity insulated with wood fibre | 40 mm |
| Cardboard vapour retarder | sheet |
| Stud structure and wood fibre | 160 mm |
| Exterior wood fibre insulation | 60–100 mm |
| Exterior airtight membrane | membrane |
| Wooden battens | 2 × 25 mm |
| Wooden facade | 25 mm |
Three layers of insulation
The wall has insulation in three places. The main layer of 160 mm fills the space between the studs. On the outside it is covered by a continuous exterior insulation layer 60 to 100 mm thick, so even the studs are not a place where heat could escape. The third layer is the 40 mm in the service cavity.
Wood fibre lets water vapour through and can hold it temporarily. The wall therefore dries slowly towards the outside, and the dew point moves towards the outer side of the wall.
What the service cavity is for
Electrical and water lines run in a separate plane in front of the vapour retarder. An electrician or plumber therefore does not have to puncture the vapour retarder, and the wall stays airtight. In the event of a water leak there is also less risk of damage to the main insulation. We added the service cavity to production in 2024, and Marek talks about it in the video.
A facade that dries out
Behind the wooden facade there is a 50 mm air gap on wooden battens. Air moves through it and carries away moisture that gets behind the cladding, so the facade can also dry from the back.
The straw variant
Instead of studs with wood fibre, the wall can be made of an EcoCocon panel. It is a timber frame filled with compressed straw, 300 mm thick. The panels are made in Slovakia, in Voderady near Trnava. Clay plaster is applied directly to the panel, and on the outside the exterior insulation and facade are the same as in the standard wall. More in the article A straw and clay house.
Frequently asked questions
Is there polystyrene or PIR in the wall?
No. All the wall insulation is wood fibre, and in the straw variant it is straw and wood fibre.
Can I choose a straw wall?
Yes, EcoCocon straw panels are an alternative to the standard wall. We set the price for a specific home in the offer.